Kyosho Triumph Rear Arm Mounts (2 and 3 degree anti-squat)

thingiverse

Rear arm mounts (part of TM6) for the Kyosho Triumph.The Triumph rear arm mounts are supported by two different blocks, which could offer different anti-squat angles depending on the hole positioning in the front and rear mounts. The stock design is equipped with 3 degrees of anti-squat - which is very typical of buggies from this era. This was more common due to the bumpier nature of the tracks. I have modeled a 2 degree version which would could help with stability on corner entry (when off throttle) and a add a little more steering; but at the cost of potentially a little less grip on throttle.The blocks are marked with small dimples to indicate 2 or 3 degrees (2 or 3 dimples). I could not find a good location to make the front mount more visible.Tap the mounting holes on the rear mount with a M4 and M3 tap. Very, very carefully ream the hinge pin holes. There is not a lot of wall thickness left in the front mount, so caution should be used when reaming. NOTE: The 3 degree mounts line up very well, but I may refine the 2 degree slightly, and potentially add a 1 degree (need to confirm clearances to the motor plate).