Kyosho Mini-Z Audi R8 MZN195 body clips (modified)

thingiverse

Kyosho's Audi R8LMS (MZN195) always bugged me with the back end of the car being higher than the front and the side-to-side wobble when used with the MR03 chassis. Made some side body clips that lower the body 1.5mm, bringing the body level with the bottom of the chassis and also .5mm wider (each side) to take up the slop. As it happens, the stock left/right ones have a 1.5mm leg, if the stock ones were mounted up-side-down (since they are L/R specific), that would probably fix the raised rear end problem. I'm also including a set with zero offset, just raised 1.5mm if you're using a lipo based car that is wider and didn't need the offset. Also one 1mm thicker on each side, but don't see any real use for these. I print these on their side (as they would mount in the body) for strength, print solid, with supports. No longer need side specific either as they are symmetrical. Note: Designed for FDM printer, not tested with a resin printer; tolerances may be off since I build in for the FDM squash. Was inspired by tailslide5_0's fantastic Jomurema clips for the Reflex RX-28 (https://www.thingiverse.com/thing:5458950).