Kyosho Double Dare and USA-1 Vintage Monster Truck Parts

cults3d

I recently started refurbishing a 1988 Kyosho Double Dare 4WDS (4 wheel drive and steering) monster truck and because some parts are broken or missing I have to replicate them for 3D printing. It shares many parts with the later USA-1 truck. Shockmount01 is an accurate copy of one side part. I didn't make the opposite side with the antenna holder. They are the same other than the antenna slot. To print left and right pieces mirror the part in the slicer. The little frame piece should be glued to the back after printing with CA glue. Shockmount02 is a modified shock mount that lowers the car in order to improve handling and reduce drive shaft angles. 4WSBracket01 is the bracket that holds the steering linkage between the front and rear steering. The wheel hubs come in two versions. 01 is an accurate copy of the originals and 02 is a solid piece without the lightening holes in the original. The rear bumper, stopper and servo mount is not accurate to the original. I don't have the original part so I designed it after looking at photos and drawings. Mirror the relevant parts inthe slicer as needed to get the opposite sides. all slicers have this option. Make one left and one right piece of each where applicable. The rear bumper is designed to be printed standing on the end and has support features included that will snap off after printing. Print the headlights from clear plastic and 100% infill to get nice lines similar to full size headlights. They are a tight fit. I used PP filament to print them.