KWA M4 Mag Pull

thingiverse

Replacing the bottom plate of a KWA M4 mid-cap magazine requires some basic tools and a bit of finesse. First, ensure you have all the necessary components, including the new bottom plate and any other parts that may be worn or damaged. Next, clear the area around your work surface to prevent any tools or debris from getting lost. Begin by removing the spring from the mid-cap magazine. This can be done by gently prying it out with a small screwdriver or similar tool. Be careful not to damage the spring or the surrounding plastic. Once the spring is removed, you should see the retaining clip that holds the bottom plate in place. Use your fingers or a small flathead screwdriver to carefully pry this clip away from the magazine body. Be cautious not to push too hard, as this can cause the clip to break off completely. With the retaining clip removed, you should be able to lift the bottom plate out of the magazine. Take care not to touch any of the internal components, such as the follower or the spring guide, as these can be sensitive and prone to damage. Now that the old bottom plate is removed, it's time to install the new one. Simply place the new plate over the retaining clip and press down gently until it clicks into place. Make sure everything is properly aligned before moving on to the next step. Replace the spring by sliding it back into its original position within the magazine. Ensure that it's seated correctly and not twisted or bent in any way. Finally, test the mid-cap magazine to ensure that it's functioning properly. Load a few rounds of BBs or other ammunition into the magazine and check that they feed smoothly through the system. If everything seems to be working as expected, congratulations - you've successfully replaced the bottom plate of your KWA M4 mid-cap magazine!