KUSBA Dragon Burner Mount v3

prusaprinters

This is one of my first designs so any feedback is welcomed!I made this mount to hold the KUSBA on my Dragon Burner toolhead for V0.2. I printed it in ABS 0.2 mm layer height with no supports. (I expect any filament would work)Instructions for mounting:Remove the two m3 screws in the front of the toolheaduse another set m3 screw that will reach the back nuts on the toolhead (45mm should be fine)Screw the mount on before placing the KUSBA accelerometer on the mount.The accelerometer should fit snug in the provided space but two holes are provided so that you could mount it if you decide to (will need nuts on the bottom to hold in place.USB-C cable should fit just fine however results may vary depending on your cable.