KTM 1290 Super Duke GT GPS Mount Extended

thingiverse

A modification of the original to bring the GPS slightly higher after feedback that a higher placement was more ideal. It was a bit of a rush and done in Tinkercad so the old bottom holes are still present and it might be less than perfectly presented. But it fits. On my 2020 Super Duke I found the original screws too short and ordered some M5 x 12mm Socket Flanged Button Screws (ISO 738002) Stainless Steel (A2) from Accu, along with some 5.3mm x 10mm x 1mm Flat Washers - TPR Rubber to be extra safe. One for each screw. As can hopefully be seen from the images, it just about clears the screen, both lowered and raised. It does not however clear if the locking mechanism is attached. I may address that by bringing the mount forward in a future release. Or I may forget! As per the original, I used a pretty high 40% infill and supports, along with thicker walls. Use your own judgement as until I've a couple of years on this I can't say what works. I did print at 0.2mm layer height.