ksger T12 TPU bumpers

thingiverse

These are protection bumpers for the t12 full size single hand tool unit t12 soldering station from ksger, the one that has the internal power supply, this might also work on the "lite" version with external power supply if it has the same height and width with only the length being different, this might also work on clones from other brand names but it has only been tested on the normal full size station from ksger, different versions of controller pcbs ie. 2.0,2.1 and 3.0 should not make a difference in the station's dimensions, the holes are made for replacing the original Philips screws with normal m3 hex screws, 8 needed, all units should have m3 Philips by default but please check just in case. there's also a better roller for the encoder that has better grip and in my opinion a better aesthetic to printed like the other pieces flat face down. the files are printed flat face down on the plate (unlike thingiverse thumbnails they should all be rotated 180 degrees), temperature is dependent on your tpu parameters but the hotter you print the more stringing so try to aim towards the lower temp margin of your material while making sure to not go too low to avoid clogs, I printed them at lowest temp + 5c but your millage may vary, and as usual with tpu print slower especially for the first layers.