Krytac trident PDW dropstock (deans suited)

thingiverse

First off all I'm not responsible for any damages you make when using this design, install at your own risk. 2 main risks: - Make sure your cables fit into the trench and don't get stuck or squished which could cause electrical malfunction (or worse). Note that I've been using this dropstock fine in combination with stock cables from the Gate Titan mosfet. For extra protection I wrapped 1 inch of electrical tape around the cables where they go into the trench. - You'll need an extra bolt (and nut) and maybe another one if your sizes are off. Make sure the bolts don't extend too far into the body (bottom one) and in the top make sure it goes as far in as your original bolt. Measuring is key. Okay so now down to the design. This design has 3 major differences from the original dropstock. 1. It will fit the m6 bolt that comes with PDW. 2. It has space to fit a Deans through instead of only Taminya. 3. The cables come out at the bottom instead of the top, which is essential for PDW since otherwise you need to dremel/modify your whole stock. So to make it clear this design does not need any modifications on your original parts; it will only add stuff. Required: - 1x nut M6 - 2x bolt m6 (I'll add my sizing later) I had to trim mine down a little for perfect fit. Reason for a dropstock is so I can use my rail as intended (rather than using a ton of risers to fit everything on, and still wear a WarQ helmet without being hampered aiming down sight.