Kryptonite Lock Clip

prusaprinters

I was unhappy with the original mount system of my Kryptonite Mini-5 U-Slot.This replaces the aluminium slot on the shackle to insert the lock into its mount.The part is a first attempt to test for durability. I will report in a few month after using it daily.I managed to fit it with friction fit (after freezing the lock in the freezer).. I don't think this will ever move, even without the set screw! (unless it breaks!)I still plan to add the set screw with a heat insert later on, the hole is already there in the model.You may need to sand the hole to get it to fit perfectly. I had to install the part using a block of wood and a mallet.The result is a part much more snug than the original, which prevent the lock from moving and eventually loosen the mount over time. I just tried it on a ride, and now the bike is much more silent as the lock is not moving around anymore.Printed in PCTG in 0.4 with 6 wallsFeedback most welcome.  UPDATE May 2024- A few month later, it is still working great. Still the original one I printed. Still holding tight. This allowed to completely get rid of the lock vibrations. Sliding the lock in its mount is much more tight than the original piece.