Kroot War Sphere

thingiverse

I increased the diameter of the pegs that connect the rings to each other and the cap piece, as well as the size of the guide pegs from the innersphere connector to the ring 2 cross beams. This improvement has made it better overall. The design is meant to be printed in multiple pieces rather than a single continuous piece, which would require complex supports that I didn't specify. To assemble the rings and cap, simply place them together with some luck and attention to detail. Start by attaching ring 1 on the inside, followed by ring 2, then finally attach the cap. Don't overthink the connections; they'll come together as intended. Once you have assembled the rings and cap, attach the inner ball to the Ring_2 cross-support piece using the guide pegs located at the end of the innerball connector arms. These pegs will help ensure a precise fit. Remember to print multiple copies of each part, including the rings and the cap.