Kral twin Magazine case

thingiverse

Twin magazine storage case for Kral air rifles. tested in both PLA and ABS, magnet holes come out a tad large in PLA and a tad small in ABS but nothing that can't be sorted with a bit of post processing. Printing: layer height: your choice, mine were 0.2mm infill: again your choice, i used 30% for pla and 100% for abs supports: no particular need for them but i did use them to get a better finish on the lettering and the curved edges. Post Print Assembly: smooth off however you like, you'll need 6 x 3mm diameter, 2mm depth neodymium magnets which can be glued into the holes. The hinge was originally designed to utilise a piece of 1.75mm filament but due to print orientation you'll need to reem the holes with a drill bit first or just use a piece of suitable thickness wire like i did and glue on each end. The case lid may catch slightly on the mags when opened and closed, simply scrape a bit of material away from the inner forward edge of the lid until you get the perfect fit (it wont take much). lettering infill was done with a few layers of paint using a syringe and paint needle then filed back once dry.