KP3S fan mount (Remix from Fukumay's and TrocheHole design)

thingiverse

This is a combination of Fukumay's lightweight fan mount for the KP3S; https://www.thingiverse.com/thing:5249055/remixes and the 4010 fan shroud from TrocheHole; https://www.thingiverse.com/thing:5391509/files Saves about 18g from the stock assembly. I used M4x6mm screws for the frame bracket that are a bit longer than the stock ones used to secure the stock cover. You could also only use the fan bracket like Fukumay's original design and secure it using tape to the extruder. I added the frame bracket because the fan bracket would shift over time if only using tape to secure it. Additional mounting hardware: 1pc M2x22mm or longer screw (to secure the top right 4010 fan to the frame and fan bracket) 1pc M2x16mm or longer screw (to secure the bottom right 4010 fan) 2pcs M2 nylon nuts (heat insert can also be used) I inserted the heater and thermistor from the left side to make the wiring neater. There is a zip tie hole on the left side to secure the wires. I used tree support on Cura to print the fan bracket to make the removal of support easier. Credit goes to Fukumay and TrocheHole for the original designs.