Kossel XL/Open beam fillament holder

thingiverse

I finally designed a self-made filament roll holder, but I've been putting off uploading it for far too long - it's been sitting on my printer for at least two months now. Fortunately, it works flawlessly, providing ample movement for the filament roll and keeping it securely in place with its thicker end section. This design is specifically tailored for 750-gram PLA rolls. I printed this holder at a resolution of 0.2 mm and an infill percentage of 50%. It's attached to my open beam using three M3*8 bolts and nuts. Print Settings: Printer: Kossel XL Rafts: No Supports: No Resolution: 0.2 mm Infill: 50% Notes: Note: Print this standing up on the side that will be connected to the beam.