Kossel Raspberry Pi mount

thingiverse

This is my version of a Raspberry Pi mount for the Anycubic Kossel Linear Plus. It will likely fit any printer with 2020 extrusions featuring a 6mm slot. The Pi sits recessed just 1mm from being flush with the outside of the extrusion, making it easy to access the USB & Ethernet ports.\r\nThe mount has a protrusion that fits into the extrusion's slot for alignment and a single 5mm (or smaller, using washers) screw for attachment.\r\nI've uploaded two versions. One features holes 1.8mm for M2 screws (they'll cut their own thread if you start slowly with pressure, works best with PETG), the other is designed for M2.5 screws (with 2.3mm holes). The Raspberry Pi's mounting holes are too small for M3 screws, and when I first designed this, I had no M2.5 screws, so I created the M2 version (I'm in the US, where metric screws are typically a mail-order item).\r\n\r\nI made this for my conversion of my Linear Plus to run Klipper firmware.\r\nSee thing 4015280 for an SKR v1.3 mount that I'm using with this (mainly for the simple configuration of TMC2130 drivers).