Kossel Delta Plus Bed Clamp with Glass Clamps

prusaprinters

<p>Designed for the Kossel Delta Plus with 240mm heated bed.</p> <p>The clamp holds a 3mm thick heated bed and optionally a 3mm glass build plate.</p> <p>I have been using this on my delta for the last three weeks and I'm very satisfied with this design.</p> <p>Material:</p> <ul> <li>Bed Clamp - Uses the screws and nuts from the original clamps</li> <li>Glass Clamp - Three M4 x 10mm screws and hex nuts</li> </ul> <p>If you're wondering what the red fan is in the photo, it's a <a href="https://www.thingiverse.com/thing:3183895">Bed Cooling Fan</a> to speed up the cool down of the glass bed.</p> <p>I installed it on the delta and wired the 12V fan directly to the Heater1 connection on the Trigorilla board. I did not use an external MOSFET as described in the Bed Cooling Fan install. The MOSFET on the Trigorilla board is quite capable of handling the load of a standard 12V cooling fan.</p> <p>To control the fan I entered in the slicer's end gcode:</p> <p>M42 P45 S255 ;(Pin 45) ;Bed Fan ON</p> <p>M190 R30 ;Set Bed Temp to 30c and wait</p> <p>M42 P45 S0 ;(Pin 45) ;Bed Fan OFF</p> <p>M140 S0 ;Bed Heater Off</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Anycubic Kossel Delta Plus</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>.2</p></div> <p><strong>Infill:</strong></p> <p>40% or greater</p> <p><strong>Filament:</strong></p> Hatchbox ABS <p>Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Designed for .2 mm layer height.<br/> Print as oriented in the stl's. <p>An X-Acto knife or drill can be used to remove the support material in the Glass Clip screw hole.</p> </p></div></p></p> Category: 3D Printer Parts