Kossel/Delta 1515 bracer corner - no disassembly version

thingiverse

# Kossel Bracer Corner I wanted to add another level of beams to my printer without disassembling it. So, I installed the bracer at a level where the carriages never interfere with my normal prints. ## Features - No printer disassembly is required for mounting. - It doesn't interfere with the belts. - Usual drop-in slots for nuts are provided in the top and bottom of the beam. - An additional drop-in slot is available on the outer side. - A nut spacer is included inside to make assembly easier. - Additional beams may facilitate diagonal bracers or plexiglass walls installation. - Small manual pads prevent corner liftoff in critical areas. ## Limits - If installed as shown in the picture, it limits your printer range. Manually test how far your printhead can move with this and only install it if you are sure you can live with the reduced build volume. This is your responsibility. - This is not meant to replace any corners with motor mounts or bearings. ## Customizing I've included the OpenSCAD files, but they need cleaning up. If there's interest in them or the files without support pads, let me know and I'll make them ready for use.