Kossel delrin carriage

thingiverse

I have numerous coils of wire that were somewhat disorganized. I was either taping the loose wire end or pushing it into the coil. A plastic clip to hold it in place would be a more effective idea - here it is. The spools I am using are typically available from Fry's and Micro Center. They measure approximately 50mm in diameter when fully loaded and around 30 mm when empty. I created two sizes for each of the two reel heights, one designed for a mostly full spool and one designed for a nearly empty spool. Unfortunately, I do not have access to an almost empty spool so I was unable to test the 30mm size but I am unsure why this shouldn't work. Printer Settings Printer: XYZ Da Vinci 1.0 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.3 Infill: 10% Notes: No special considerations were necessary for this print. I utilized a glue stick to attach the print to the bed and it turned out fine, no rafts or supports being required.