Kossel Clear PSU mount for under MDF board

thingiverse

This clip was created by my friend Dumle29 with dimensions specified by me. Please refer to the Instructions tab for usage guidelines. Read all instructions thoroughly before assembling. If you have any comments or concerns, contact me via the comment section or my Thingiverse profile. Instructions: Print three copies of these clips. Remove your MDF board/heated bed from your Kossel and place it face down. Secure your PSU to the MDF board with tape or hold it in place. Position one clip on one side of the PSU and two on the other, then mark the drilling points with a pencil. Remember, mark twice, drill once. Be cautious when working with MDF boards as they are soft and prone to errors. Choose between a 7/64" or 1/8" drill bit for hole drilling depending on your preference. After drilling the six holes, flip the board over to its normal side. Use a drill bit that matches the size of the M3 bolts' heads to recess the screws slightly. Exercise caution during this step, as the drill may penetrate the entire board if it grips too firmly. If possible, use a drill press for better precision. Finally, insert M3 bolts through the board and into the nuts that are recessed in the mounts. This should complete the assembly process without any major difficulties.