Kossel Board Holder Micromake v1 board

cults3d

I felt the original was a bit too filmxy and I didn't like that the board sat without any standoffs, I added nut holes on the bottom to help for threading and raised the board up about 2MM to allow for more airflow, to replace the removed under fin I added two side stabilizer rails that are designed to allow for the wiring to be freely connected though it has an enlarged opening on the power supply side to allow for easy wiring of the heater. To further strengthen it a cosmetic faceplate cover. Please note that you may need to drill the holes in the faceplate to allow for easier fitting of the m4 bolts but they can also be simply threaded in. Parts required are 4 M4-10 bolts 2 M4 T-nuts. 4 M3-6 Bolts 4 M3 Nuts