Kohler faucet mounting nut

cults3d

I created my under-sink washer for mounting the Kohler faucet in a single hole when the metal bracket that shipped with the faucet didn't fit the area we had to mount it in. It was born of necessity and proved to be a quick print that worked well right off the bat. When I went to install it, however, I couldn't find the large mounting nut that came with the faucet to hold the faucet in place. I searched high and low but just couldn't seem to locate it anywhere. So, I headed back to the 3D printer once again. A quick sketch, some dimensions, and a roughed-up shape later, we were good to go. I measured the thread of the long rod that holds the faucet in place - it's a standard 1/4" x 20tpi, which is a standard thread in Fusion360. Yes, this is listed as a remix because these parts are directly related. I printed it up using a 0.200mm layer height because I was feeling impatient. Usually, I would do threaded parts with a 0.100mm layer height, but it worked out well as the thread came out a bit tighter and so was like threading on a nyloc nut. It took a whole bunch of turning to get it tightened up properly because the threaded rod is so long, but once it did, it was nice and solid.