Kobalt 24v Battery Mount for Standard Pegboard

thingiverse

I printed Rick's 24v battery mount and then remembered that my wall is all pegboard and it would be best to be able to move my mounts around as my tool collection changed. So I added pegboard hooks to his original design, but then also created a slanted ("Angled") version to make removing the battery easier. I haven't printed enough of each to determine whether the slanted one is better or not, but I like it better. This fits my 1/4" holes, 1 inch spacing. Print standing upright. Supports are needed for the hooks and maybe for the top front overhangs (I do). But if you do the front overhang at the top, you'll want to figure out how to block supports from going to the walls, otherwise it can be difficult to remove the supports since it is a tight area. BUT - that all depends on how your supports print. I'm not an expert on them.