Knuckle Grips 23.mm for bicycles

thingiverse

I'm eager to try printing some bike grips and brass knuckles. The test print, shown here, turned out decently. I sliced the model in half for testing purposes only. Originally, it was printed vertically. I'll update this remix with a vertical print later at 0.2mm resolution. Test print quality settings are as follows: Excuse the poor quality of the print. To speed up the test print, I used an 0.8 nozzle. My settings are: Layer height is 0.48mm Width is 0.8mm Perimeters are set to 6 for added strength Infill is 20% Lines Supports are turned off The test grip stands about 106mm tall, and the knuckle diameters might be a bit small for some people. I wear a large in work gloves and the knuckles fit snugly but don't cause any issues with fitment. A Tinkercad link is provided for those with smaller fingers; just edit and print your sizes. Don't forget to give a shoutout to this remix and its sources. https://www.tinkercad.com/things/7oaSXjbbcoJ Good luck printing, and enjoy! Peace out.