Knife stand for joseph joseph dish rack

thingiverse

Joseph Joseph make a nice drying rack, but it lacked the knife block holder of our previous simple human rack. Without that, all our sharp kitchen knifes were over balancing and being annoying. So I made this. It converts ~2/3rds of the provided cutlery holder into a knife block where they can stand safely upright and drain. Its not perfect, but its printable and fits the rack well enough. I think it needs a bit of trimming as the cutlery rack gets narrower as it goes down, the model doesn't. But this is functional! If anyone re-mixes I may re-print... Printed fine, if slowly, on my monoprice mini. No rafts, supports etc needed, but ~80g of filament.