Knife sharpening

thingiverse

This is my inaugural project, and I apologize in advance if the details are incomplete. List of Materials: * 16 mm aluminum tube for main body * 8 mm aluminum tube for vertical stand and slider * 2 x 8 mm linear bearings * 1 x standard bearing (6 mm inner diameter and 19 mm outer diameter) * Various 3-4 mm screws and nuts Stone Dimensions: 13x25x100 mm Update 1: For the table, I utilize a piece of Komatex with 8 mm neodymium magnets. In my opinion, this is the best solution because you can easily move the knife if the blade is curved. Update 2: To set the angle: place the knife on the table, position the stone on the knife blade, and adjust the angle by moving the vertical stand. The upper mark represents a 10-degree angle (the large triangle corresponds to 10, 20, and 30 degrees). Update 3: I modified the back main support to print without any supports, and extended the length of the front main support for added stability. Print Settings: * Printer Brand: RepRap * Printer Model: Graber * Rafts: No * Supports: No * Resolution: 0.2 mm * Infill Percentage: 15%