KMi Beast - pylon racer

cults3d

Wingspan 900mm Length 750mm Checkout my channel for the video: https://www.youtube.com/watch?v=vO2427sjjbA&list=PLmt1aJpXkmizz-fdDmVnwffqsiarPh1dG&index=12 Test AUW: • 760g Tested power: • Motor – 2826 – 2200kv • Esc: 40amp • Battery: 3-4s 2200 120c • 5x5 prop (all the way up to 5x7.5) Other electronics • Min 4 channel Rx • 3 9g servos Needed parts: • 6x4x1000mm CG tube • 10 M2.3 screws • 450mm pushrod (x2) o One full for elevator o One to be cut for ailerons Optional parts • 6x1x350mm pultrude – There is a slot to use from fuse 3 – 6 that you can slide this into to stiffen the tail. If you are going for speed, I would suggest this option. • 3x1 pultrude – used for hstabs. Adds extra rigidity to the tail. If going for speed it is suggested. • Landscaping flags – Wire to be used in the alignment holes. I noticed this added some extra rigidity to the walls when used. This is also best used for the aileron and elevator hinges. A pushrod will work but allows more play and if going for speed, that is not ideal. Material built for: LW-PLA(HT)/PLA/PETG This is built for fuse (2-6) and wings to be printed in LW PLA. Fuse is double wall so it is not recommended to print in PETG/PLA unless you add a motor prop setup to account for the additional weight. Fuse 1 and Fuse 1a should be printed in PLA/PETG since they slide together and screw. Notes: If you need another bolt patter for the motor mount, please contact me and I will get one for you to print