KMi Ammo Pylon RC Plan - Fuse 1 and fuse 6 Test print

thingiverse

Wingspan 800mmLength 750mmVideo https://www.youtube.com/watch?v=8wdI1di3RkQFull FIles: https://cults3d.com/en/3d-model/various/kmi-ammo-pylon-rc-plane-kmi3dprintTest AUW:• 730gTested power:Motor – 2808 – 2300kv2216 -2400kvEsc: 40amp50amp escBattery: 3-4s 2200 120c5x5/6x4.5 propOther electronicsMin 4 channel Rx3 9g servosNeeded parts:6x4x1000mm CG tube16-20 M2.3 screws450mm pushrod (x2)One full for elevatorOne to be cut for aileronsOptional parts6x1x350mm pultrude – There is a slot to use from fuse 3 – 6 that you can slide this into to stiffen the tail. If you are going for speed, I would suggest this option.3x1 pultrude – used for hstabs. Adds extra rigidity to the tail. If going for speed it is suggested.Landscaping flags – Wire to be used in the alignment holes. I noticed this added some extra rigidity to the walls when used. This is also best used for the aileron and elevator hinges. A pushrod will work but allows more play and if going for speed, that is not ideal.Material built for:LW-PLA(HT)/PLA/PETGThis is built for fuse (3-6) and wings to be printed in LW PLA. Fuse is double wall so it is not recommended to print fully in PETG/PLA unless you add a motor prop setup to account for the additional weight. Fuse 1 and Fuse 2 should be printed in PLA/PETG since they slide together and screw.Notes:If you need another bolt pattern for the motor mount, please contact me and I will get one for you to print3D PRINTING SETTINGSFuse1Wall:.16top: 4Bottom: 6Vase mode: Noinfill 20%Material: PETG/PLAFuse 6 .Wall: 2top: 0Bottom: 2Vase mode: YesInfill: 0%Material: LW