Kloonituubi-stock-remix

thingiverse

A modified stock from the Kloonituubi gun stock, which is itself based on the Protube VR. Design changes focus on extra rigidity and comfort. Stockv8-kloonituubi is compatible with Kloonituubi. I adjusted the teeth of the hinges and controller holder to make them more prominent. This should enable the joints to snap into place more easily while keeping them secure. All parts starting with Knoose are compatible with each other but not with kloonituubi. I aimed to keep a similar naming convention as the original design, both to show its origin and to allow users to follow the construction manual for this build. These modifications are mostly minor adjustments to an existing project. Almost all of the work has been done by Ajantaju, so I give him credit where it's due. I used shorter lengths of tubes due to limited space in my play area: 2x 12cm and 1x 18cm. (for those living in the Netherlands, GAMMA has a darkened tube available at their curtains section for approximately 7 euros. It is the one I use in the photo.) v2 Edit 27-09-18: After testing the new teeth myself, I found they locked the joints in place a bit too well, making it difficult to adjust the stock to different positions. For me, this isn't an issue since I keep my stock in one position, but others might find it problematic. v2 has widened teeth, which makes it a little easier to adjust the stock while maintaining rigidity. I recommend printing v2, as I also added more body to the holders for the controllers. v3 Edit 29-9-18: Although using the stock significantly improves my sniping performance, I still noticed some difficulty when sniping long distances. The joints would bend slightly sideways under pressure, decreasing accuracy over very long distances. v3 parts should address this issue or at least reduce it. edit 1-10-18: Minor design error There was a design error in v2Knoose_Lupaava_Kloonikahva. Please redownload the file and discard any previous versions from before this edit date if you have them.