Klipsch R-25C Center Channel Speaker Wall Mount

thingiverse

Updated 2017feb07: v1.0.1 fixes some calcs that prevent increasing mount tab beefiness, plus beefs it up from 3mm to 4.3mm just in case (plastic is cheap!). V1.0.0 models are still there for comparison but suggest going for the big one. My original is still holding strong like in the picture above, but another person had theirs separate - although that might have been their print settings. Full details below... // model: Klipsch R-25C Center Channel Speaker Wall Mount // author: fiveangle@gmail.com // date: 2017feb07 // ver: 1.0.1 // notes: Uses original speaker terminal mounting screws so no alterations to the speaker are required // history: // -1.0.1 - 2017feb07 - Fixed incorrect calculation that resulted in Mounting Tab being thinner than expected // - Increased Mounting Tab Thickness from default 3 to 4.3 to ensure adequate strength when installing with long mounting screw (to get it to angle downward) which could pull layers apart from the unexpected increased horizontal load // -1.0.0 - 2015jul11 - Released https://www.youtube.com/watch?v=0fwAMgrbJJg Print Settings Printer Brand: Printrbot Printer: Simple White Rafts: Doesn't Matter Supports: Yes Infill: 100% Notes: If printing tapered, suggest 100 micron and 200 micron for flat version. Enable supports everywhere then scrape them out through the screwHeadHole. If using Simplify3D, set support resolution of 2mm and preview to ensure support is oriented at right angle to the screw slot. If it isn't, change Support Infill Angle value by 90 deg (default is 0).