Klipsch Image ONE (II) Headphones replacement hinge

thingiverse

Here is the rewritten text: This set of replacement parts is specifically designed for fixing one pair of Klipsch Image ONE (II) Headphones by replacing their hinges. To assemble this new part, you will also need 3D printed pieces along with a #4 (.112-40 UNC) X .50 long screws, three nuts measuring 3/32" in thickness and 1/4 inch in width, and the original hinge pin. The cover section goes directly over these protruding screws after you're done assembling it. If the holes for the hinge pin become closed or too small during printing, a little bit of cleaning with a 1/16" drill bit will be enough to open them up again. For optimal results, it's recommended to print this part in high-quality mode because of its intricate design geometry.