Klipper Pressure Advance Tower V2

prusaprinters

I prefer this model better than the original.Lightweight, fast, & easier to read.Print:1 Bottom layer0.2mm layer height1 Perimeter0 Top layer0 InfillSet all speeds to 100mm/s, except the first layer speed. Use your default value.Important in Prusaslicer:Under cooling: Set to 0 "Slow down if layer print time is below"Otherwise 100mm / s cannot be achieved.AndTurn off "Lift Z", during retraction, so as not to falsely trigger the TUNING_TOWER COMMAND .... procedure.Continue the procedure.https://www.klipper3d.org/Pressure_Advance.htmlFor Direct drive extruder, I prefer to use FACTOR = .01, instead of FACTOR = .005.The precision is good enough anyway, and the printing time goes twice as fast until you find the sweatspot.