Klinklang Figure

thingiverse

A figure of the Pokémon Klinklang stands still, unfortunately just a statue. Its size is pretty small by default, so scaling it up might be necessary, keeping the same scale factor for all pieces in mind. All those who printed the large gear before June 29th will have to print it with the new STL since I forgot to run a boolean difference operation. Alternatively, drilling a hole could work, but that's not advised. Print Settings: Rafts: Yes Supports: Yes Infill: It depends Notes: Print the rim with very high infill, at least 75%. The base should have at least 60% infill, the large gear at least 25%, and Gear 2 (the small one with pegs sticking out) should have at least 30%. Everything else can be standard. Printing everything with a few more shells will make it easier to sand or file later. Post-Printing: If the pegs don't fit, use sandpaper and file until they do. Glue is needed to hold everything together.