KK2.1 Case

prusaprinters

<p>UPDATE</p> <p>-4/23/2013, Added a case with no buttons.</p> <ul> <li>2/19/2014, Night: Updated case on thin section between the hole and the buzzer port, and removed two holes near them. Improved alignment of buzzer port and voltage port.</li> <li>2/19/2014, Morning: Screw holes on the old base did not go all the way through, I used a drill to drill them out. I updated the design to have proper holes.</li> </ul> <p>Changes from 3dxl KK2.0 case design:</p> <ol> <li><p>Flipped the case upside down because I did not want to print supports. Unfortunately you loose the little notches on the buttons, but I found I could still press them easily.</p> </li> <li><p>Changed the clipping and swivel of the case on the base to a screw fit. I used #6 bolts from Home Depot.</p> </li> <li><p>Changed the screw layout on the base to fit this design: <a href="https://www.thingiverse.com/thing:32281">http://www.thingiverse.com/thing:32281</a></p> </li> <li><p>Added holes for the KK2.1 board buzzer and battery power port on the case.</p> </li> </ol> <p>I did not change the lid at all, but I left a screw hole in the middle of the base so that this could easily be changed. I do not use a lid on my quadcopter.</p> <p>Enjoy!</p> Category: R/C Vehicles