Kitten feeder for cerebellar hypoplasia

thingiverse

NOTE: This requires 4 M6x25mm hex bolts and nuts. Description: ------------------------------------------------------------ An adjustable feeding tray for kittens with cerebellar hypoplasia. Cats with this condition have a hard time eating as they are very wobbly, this tray allows you to adjust the feeding height to what's easiest for them, and can grow with the kitten as you adjust it. This is untested with full grown cats and will probably need adjustments to work with a full grown cat. It will take time for your kitten to learn how to use it, and it may need adjustments. There are holes in the sides for attaching bumper plates if the entrance is too wide for your kitten. How this is supposed to work is allowing the kitten to lean on the walls while eating, but yours may figure out their own way to use it. PRINTING:---------------------------------------------------- There is a V1 and V2, V1 has attachment points in the back so you could design an extension to add if needed. V2 is smooth and much easier to print. Print the walls upright, I had no issues on a Prusa MK3s at 0.20mm Quality setting. For V1 you need supports on just the back of the walls. V2 needs no supports. The food tray holder is just printed upside down and prints very easily. The center hole is 4.7" wide with a slight inward slope. You need to pause the print and fill the feet voids with sand or gravel to weigh the whole assembly down so it doesn't slide around.