Kiteboard Kitesurfing Fin

myminifactory

I think the name says it all; this kiteboard fin is based on the Liquid Force 'GTS 2.0' model, so if you have a board that fits these, you can use this 3D printed version without any problems. This is not just a test piece; I now use these 3D printed fins on my board regularly. I've been printing them on an Up! Plus 2 printer using the 0.15mm layer settings and solid fill for added strength. To finish off the outside surfaces, I also add a small amount of acetone, but the quality of the Up! Plus 2 has been pretty good, so you don't necessarily have to do this. Check out my blog to read how these were developed and tested (https://edditiveblog.wordpress.com/category/kitesurfing-and-sup/).