Kiteboard Kitesurfing Fin

pinshape

I've been using a kiteboard fin based on the Liquid Force 'GTS 2.0' model on my board for some time now; it's a design that fits perfectly with this model, so if you have a board that matches these specs, you can use this 3D printed version without any issues. This isn't just a test piece; I actually rely on these 3D printed fins on my board. I've been printing them on an 'Up! Plus 2' printer using the 0.15mm layer settings and solid fill for added strength, which has produced some impressive results. I also use a small amount of acetone to finish off the outside surfaces, but the quality of the 'Up! Plus 2' has been consistently good, so you might not need to do this. Check out my blog to read about how these fins were developed and tested (http://edditiveblog.wordpress.com/category/kitesurfing/).