KitchenAid Pro 600 Cord Holder

prusaprinters

<p>KitchenAid Professional 600 Cord Holder. Place to coil up the cord instead of wrapping it around the neck of the mixer.</p><p>Prints as 3 pieces, no supports required.</p><p>Any filament can be used.</p><p>Uses 2 M3 20 Hex heads to assemble.</p><p>Base piece can be glued on or just let the screw hold it on.</p><p>The mixer uses a short #6-32 (or very close to that) Does not seem to be metric. I used a #6-32 ¾" and cut it down to about &nbsp;½"and it worked well. Just make sure the screw does not go in too far and cause and issue. There is power back there.</p><p>Note: This is what my mixer had for a screw. Yours may be different, check before you purchase a new screw!</p><p>Second note: To keep the thin metal wrap in place while you remove and replace the screw, use some blue tape ( of similar) to hold it in place as far back on the mixer as possible. Otherwise it falls off, and makes it harder to &nbsp;put the cord holder on.</p>