Kitchen Sink accessories rack

thingiverse

Need a sturdy rack to hold all brushes and sponges around the kitchen sink.\nUpdate 1:\nThe original design features two sticks at a 22.5-degree angle, now enhanced with a second bar boasting a 45-degree stick and a third bar sporting a 45-degree section followed by a 22.5-degree "hook".\n\nPrint Settings\nPrinter Brand: \n Wanhao\n \n Printer Model:\n Wanhao Duplicator i3 V2\n \n Supports:\n No\n \n Notes:\n The success of this project depends on the quality of the filament chosen and the weight of accessories attached.\nI printed the left and right brackets with PLA at 35% infill, while the middle bar was printed with 80% infill. The design worked perfectly, although its durability under water splash remains uncertain. If it breaks, I plan to re-print it using ABS.