Kitchen Faucet Dual Aerator Set

cults3d

This is a 3d printed dual aerator for kitchen faucet which you can switch between concentrated or spray type water pattern for your dish washing need. Each aerator and attachment has 3 variants, you can mix and match according to your needs. The demo video is using the high flow with Aerator B type, your results may vary as the one in the video is a rather old design but similar. In the demo video there are no stopper, leaving the faucet aerator has 3 aerator modes instead of 2. https://youtu.be/Q15hPxX8xXs The thread for the attachments are M24 x 1mm. I tried to make things small and simple possible but I couldn't think of a better way without needing to print an extra key to turn the attachment into the faucet. You could leave out the aerator, by just using the attachment itself also works but it will make a huge mess if you're not careful. FLEX variant are intended for tpu or flexible filament types. These has no tolerance gap to eliminate any water bleeding from the top of the aerator's dome. This has not been tested, theoretically it should work with more friction comes to mind. Gasket also included just in case if your rubber o-ring has been destroyed and it should be printed in tpu or flexible too