kitchen drawer handle

thingiverse

This object was made in TinkerCad. Edit it online https://www.tinkercad.com/things/45wwlkXfPyN Kitchen drawer door handle snapped off. The handle to my drawer door snapped off, so we have to open the other door next to the broken one. The handle looks like two L’s stacked onto each other with the bottom of the two L’s being the area that goes into the drawer. The problem of the broken handle affects everyone. However, it doesn’t affect anyone in a serious matter. We just need to open the door next to it to open the broken one. The problem is located on the island area of our kitchen. It is on the outer side of the island across the area where the sink is. Fixing it is important because it would end up saving us even a few seconds of time to grab something out of the drawer. It would help if we were in a rush for a frying pan and needed to grab it as soon as possible. I believe it can be something that 3D printing can fix because it is a small object that just needs to be slid into the area. The color of the handle is a silver metal type of color. A gray color can work as a substitute. The solution would solve the problem by having a faster method of opening the drawer. The size of the handle is about one inch in height and about a millimeter in width. The actual measurements of the handle are Length– 1 inch Width–.9cm Height–1 inch Inside Diameter– .5mm Outside Diameter–1cm One problem the handle might have is, it’s a screw type of edge on the end of the handle.I believe the solution to this problem can last for a long time depending on if it breaks or not.I think the solution can be used for many things if you have a drawer that's similar to the one the handle needs.The best color of filament would be around a light or dark gray color.