Kit Axe X Wanhao suplicator I3 V2.1

thingiverse

It seems like you're sharing a DIY project for upgrading an Nema17 engine on your 3D printer's X axis, along with plans to install an E3D V6 hotend. Here are some key points from what you've shared: 1. **Project Overview**: You've created parts to adapt the Nema17 engine and its rods for a better fit in your printer. This includes making adjustments for easier cable management, panel fixing, and underside access. 2. **Future Upgrades**: You plan to replace the current hotend with an E3D V6 and also install a flexion extruder. The E3D V6 will be sourced from AliExpress, and you've already found an alternative that costs less but meets your requirements. 3. **Cooling System**: You've designed an adjustable support for the cooling system's height, which was printed along with a cooler for printing and an MT2 cooler for the E3D V6 hotend. 4. **Project Timeline**: The project is currently at version 0.0 (Creation), indicating that this is the initial stage of development. 5. **Materials Needed**: - Kit Axe-X - Insert M3 x D4.6 x L5.0 - E3D HOTEND - Extruder FLEXION for E3D - Plastic reed sensor 2.5*14 - Round neodymium magnet 6*3 6. **Adjustments and Notes**: - The holding block for the E3D V6 hotend needs to be modified by removing a corner and filing down the side. - You've used an end switch for the X axis to make a filament detector, which was inserted into the "Filament" part after calibration adjustments. - The screws provided with the extruder were too short and needed additional support. 7. **Update**: Your last update was on 2020/04/03, where you completed version 0.0 of your project by adding STL files and photos. This summary captures the essence of your DIY upgrade project for your printer's X axis and future plans to enhance its capabilities with an E3D V6 hotend and a flexion extruder.