Kingston FCR-SH4 card reader holder

thingiverse

I recommend printing it standing up to achieve maximum layer strength, tilted 45 degrees for even cooling and a smooth finish, with a 5mm brim. There are three versions available, each slightly wider than the previous one as V1 was a bit too narrow. Each successive version is 0.3mm wider. I was pleased with V1 but created additional versions for users to choose from at their own preference. Some post-processing may be necessary to round off any sagging that might occur. If you want to make modifications, and need it aligned to an axis, rotate -45 degrees. https://www.reddit.com/r/3Dprinting/comments/ehknck/am_somewhat_proud_of_this_one_card_reader_mount/ If you find this helpful or entertaining enough, tips are appreciated.