Kingston FCR-SH4 card reader holder

cults3d

I recommend printing it upright to achieve optimal layer strength, aligned at 45 degrees for uniform cooling and a polished finish as specified in the file. A 5mm brim is also recommended for stability. There are three versions available, each with an increasing width due to slight adjustments made from one version to the next. Version one was slightly narrower than desired, prompting the creation of subsequent versions that are 0.3mm wider than their predecessors. Although I am satisfied with version one, it's been prepared so users can choose their preferred option based on individual needs and preferences. Some post-processing may be necessary to smooth out any drooping or sagging that could occur during printing. If modifications need to be made and alignment to an axis is required, a simple rotation of -45 degrees should do the trick. For more information or to discuss this design further, visit https://www.reddit.com/r/3Dprinting/comments/ehknck/am_somewhat_proud_of_this_one_card_reader_mount/. Your support in the form of tips is also appreciated if you find this helpful.