Kingroon KP3S BMG V6

thingiverse

A tool head carriage for the Kingroon KP3S printer. This will allow you to mount a BMG extruder onto the exist rail block with a direct V6 hotend. And it utilizes Prusa i3 MK3S' fan duct for better part cooling. It is based on these works. https://www.thingiverse.com/thing:4653991 https://www.thingiverse.com/thing:4609524 You have to use ABL sensor(BLtouch/clones) for Z homing due to shorter hotend compared to the original. ABL sensor can be installed left side of hotend or its right side. Left side is closer to the hotend, so it can probe larger area. But be aware of possible heat damage. Notes : - You may lose 15mm of Y build volume - Z Probe Position (left) : X -29.5, Y 0.5 Parts : - (2) M3 x 6 mm Screw - (6) M3 x 10 mm Screw - (4) M3 x 12 mm Screw - (3) M3 x 40 mm Screw - (3) M3 hex nuts - Some zip ties - E3D V6 Full - Direct - 24V - Hotend - BMG (or clone) Right Handed Dual Drive Extruder - BLTouch (or clone) Bed Leveling Sensor - Short Body Nema 17 Bipolar Stepper Motor - Blower Fan 24V 5015 Slicer settings : - Print with PETG or ABS. - The fan duct is very close to the hotend, so print it with ABS or similar high temp materials. - 0.2mm layer height - 3+ perimeters - 5+ top, bottom layers - 20% infill, grid pattern - Print it with support except screw holes. Firmware updates : - E-steps : 810