Kinetic Sand Art Tabletop Enclosure

prusaprinters

This enclosure is intended to be used with SCARA robotic arm: https://www.thingiverse.com/thing:5907176 or https://www.printables.com/model/475687-scara-mechanism-for-kinetic-sand-artComponents:(1) Plexiglass - 1/4" (6.35mm) thick x 18" (457mm) diameter (top)(1) Plexiglass - 3mm thick x 388mm diameter (under sand)(0.5) Yd. White Flocking Velvet (spray glue to sand side of 3mm Plexiglass)(1) 2 Way Power Splitter, 1 Female to 2 Male 5.5 x 2.1mm Cable(1) LED Strip Light SMD 5050 RGB+44 Key Remote+12V Power Supply(1) 4 Pin 10mm RGB LED Strip Light Connector Extension Cable 1M(1) Lb. Extra Fine Sand or Baking Soda(1) Steel Ball 10-12mm diameterHardware:(4) M5 x 16 Flat Head Screws(4) M5 Flat Washers(4) M5 Lock Nuts(2) M3 x10 SHCS(2) M3 Flat Washers(2) M3 Lock Nuts(1) M4 x 16 SHCS(1) M4 Flat Washer(13) M4 Hex Nuts(12) M4 x 10 SHCS(24) M3 x 10 SHCS(24) M3 Hex NutsPrint SettingsPrinter Brand:PrusaPrinter: I3 MK3SRafts:NoSupports: YesResolution:0.2 mmInfill: 20%Filament: Hatchbox PLA Various Notes: Legs_x5, Leg_With_Channel, and Mask_Coupler_x6 are printed vertically and should have a 5-10mm brim. The screw holes in the legs are skinned over to improve bridging at the hex nut features. Drill or clean out the holes before assembly.Base\_Segment\_A, B and C require small build plate supports beneath the vertical dovetail features.Base_Segment_C and Clamp contain features that are unique to the power splitter and LED controller that I used. Use the provided STEP file to modifiy the geometry to match your components and then create new STL's as required.Custom SectionCompleted Application   Category: Decor