Kinesis Advantage Orifice Plug

prusaprinters

I replaced the logic board in my Kinesis Advantage with the KinT controller. This deletes the original cables, and leaves you with holes in the back where your USB cable gets run. Instead of trying to reuse the original grommets, I made these.The strain relief plug likely needs to be cut down its axis to wrap around a cable. I used a very sharp razor blade for this and was very successful.The blank plug is not D shaped like the hole, but fits without issue on my keyboard.All parts:Print in TPUSupports aren't really possible, some post processing with a razor may be necessaryI highly recommend “concentric” top and bottom layersOpenSCAD model available if different sizing is preferredThe BOSL2 library is required to use this SCAD document