Kids Dino Cage

prusaprinters

Pictures show Rev0 before I realized one of the snap slots was way off so there are considerable gaps.  These should all be fixed now so the updated versions fit together quite well.  Included are two sizes 70x70mm and 100x100mm but the kids are pushing for a rectangular version.  I will try to make that and post it in the next few weeks.I have been surprised how many hours the kids have played with these!For assembly place the side with a single middle peg on a flat surface then slightly flex the two corners up to help spread the double center pegs apart.  Once all 4 sides are connected snap on the top and bottom.  I found it easiest to set the 4 sides on a flat surface then slide on one side of the top/bottom then push down to snap on the other side.  You can use brute force to attach the sides but the above method works the best.Post any questions or design suggestions as I am always trying to improve my creations :)