Kid Proof MotoX NightScout Case

thingiverse

This case safeguards a MotoX and Dexcom G4 receiver. The receiver fits snugly in from the top, while the phone slides securely into place from the front. It has proven to be very durable so far. Instructions I produced two of these items using 1.75mm ABS with print settings of 240c for the base and 100c for the supporting components, utilizing Cura software. The initial assembly plan had only two pieces but due to difficulty in providing support, it was modified to include a third part. To minimize warping, my print bed is prepared with masking tape and a light coat of purple Elmer's glue stick. For optimal results, I suggest employing "Brim" and readjusting the parts to lie flat on your bed. Optionally, using "support everywhere" can assist in bridging the port within the DexCase. Hardware List: (6) M3x16mm Cap Screws (3) M3x10mm Cap Screws (8) M3 Nuts (1) 97mm Micro USB www.ttvjaudio.com/Nightscout_TTVJ_Micro_USB_to_Micro_USB_Cable_p/ttvj000001.htm RED end to phone