kfsdigare

thingiverse

Customized Version of Thing: 175150 Created with Customizer! Http://www.thingiverse.com/Apps/customizer/Run?Thing_id=175150 Instructions Using the Following Options: Plate Thickness Equals Three. Slit Length Measures Twelve Inches. Line 9 Reads Line 10 Will Remain Empty. Line 8 Is Not Set to Any Value. Line 7 Remains Unchanged as of Now. Line 6 Displays No Information. Line 5 Fails to Show Any Content. Line 4 Remains an Acronym Stands for W.R.E.R. Line 3 is An Acronym And Represents K.N.K.W Line 2 Reads Out as a Logical And Corner Radius Amounts to Three Degrees of Arc Measure in Inch or Decimal Fractional Measurement with Three Being Equal and Not a Degree. Font Size Measuring Eight Points is the Standard Setting Now. Text Styling Parameter is Set to Negative Eighty Which Affects Display of Any Number or Letter or Special Character as Part of Overall Text Display. Slit Width is Specified Four by Four. The Units Applied Were Presumed in Either Millimeter Or Inch Measurement Systems Used Internationally. Spacing Between Lines is Established Two by Two and Applies for Line Six Including Upward And Downwards Alignment from Bottom. One Measure is Stated, Letter Spacing which Reads One, Hence a Single Character or Figure Width as it Concerns This Special Format. The Chosen Font Being write/orbitron.dxf Will Get Displayed Following Preset Setting Given For this Design of Specific Parameters Now Set.