Keystone Surface Mount (single)

thingiverse

This is a custom design based on jsadusk's original creation with added mounting flanges for use in my Tinker Friendly Ikea Lack printer enclosure. These mounting flanges make it incredibly easy to disconnect and reconnect the case LEDs, spotlight, mixing fans, cooling fan, and filament run out sensor that are mounted on the removable enclosure top. To complete this project requires 2 #8 wood screws and a cat6 keystone jack. The original blank design was too small for my Keystone jacks by about 1mm, which meant they wouldn't fit at all even with some trimming with a razor. I adjusted the fit in this custom design, resulting in keystones that snap in easily. There is a small gap on two sides of the keystone's face once installed, but it's barely noticeable and they still hold very securely.