Keyforge Single Archon and Token Box (v 2.0)

cults3d

The evolution of my previous design -- the primary change you'll notice are rounded corners. This causes printing to be much, much easier. Less lifting, fewer failed prints. Additionally, the drawers have a slight raised internal tab to cause them to sit more flush with each other to hopefully prevent any escaping tokens or small components. The lid is also curved and it is intended to slide in in one direction. Note one of the short edges is flat/vertical rather than angled. That one goes on the outside. The large tray spaces are the right size for a sleeved deck. So if you can fit everything within one large tray, you can fit two archons in, technically. There are two lid options, and two small tray options. There are also two chain tracker card tokens you can print and use, optionally. *UPDATE: 04/13/19 - Added a divided tray with the divider offset a bit. I found that the standard cardboard key tokens didn't quite fit in one of the divided compartments. Now they should be able to, and give those with those keys a bit more options on where to put everything. “KeyForge is a Registered Trademark of Ghost Galaxy, Inc. 2022 All Rights Reserved.”)